PlanetZ forums - scopeusers.com

I use Power Quest BootMagic version 1.01., to partition my two 10GBs drives.

The software was included when I bought the system about 5 years ago, from Area51UK, from London. They didn’t include a CD of the software and so, I have not a copy. I’ve been told it was a promotion and they had installed BootMagic 1.01 from a magazine, something like Computer World, or CD review, or something like that… can’t remember. This software was for free. I never realised I would some day need this… unfortunately.

I have two partitions in my drives: the Studio one and the Office one. The Studio one can’t be loaded now, cos BootMagic asks for a file called BTMAGIC.IMG, this file DOES exist in fact, I have searched and found it, but there is no way to load the Studio partition it anymore…

There is a message suggesting me to run the install again. I don’t have the software nor the money to buy the new version, which is the 8 one.

Please, if you have suggestions, or even better, if you are one of those who have the free version in a CD, please, let me know so I can get it, if you are kind enough to send it to me.

It’s real bad, I can’t do a thing, this problem is certainly out of my hands…

Thank you.

Nestor, there's a file on Powerquest's ftp site called BMwin100-101.zip - looks like an update, but the file is 1.5 mb so it's likely a full install. Running it should repair your installation
Get the file at:
ftp.powerquest.com/pub/old_updates/BootMagic/BootMagic1/BMwin100-101.zip


If you can't get it I'll download it and email attach it to you.
/dave

<font size=-1>[ This Message was edited by: dbmac on 2003-02-02 22:30 ]</font>

Thanks very much. I'm going to try this as soon as posible. I have to travel for a couple of days. Thanks very much again for your help. If I can't get it, I'll let you know, thanks...

<font size=-1>[ This Message was edited by: nestor on 2003-02-02 22:30 ]</font>

Thanks very much Dbmac for your help. I did it, I've upgraded, but nothing happend. What else could I do? I don't know how to reemplace the lost file...

Perhaps something here may help:

"Among these is BTmagic.img, the file BootMagic uses to display the BootMagic Menu. BootMagic allows only one copy of BTMAGIC.IMG among the primary partitions on the master drive. A check confirmed that it does not object to such copies on the slave drive. No operating system will boot if either the MBR or the partition with the BTMAGIC.PQ folder goes sour. Should this occur, a BootMaster Rescue floppy can be used to hopefully recover. Also, BootMagic may be disabled and re-enabled as the need arises."

Also, have you looked here:
http://www.powerquest.com/support/primus/id566.cfm

Thanks Spirit, I'm going to go deep into it, to try solving the problem. Thanks very much!

It seems incredible how important a few words can be… Your help just saved my work, and much, much time I’ve spend onto it…

Thanks very much to you all, cos with your help and guidance, I’ve found my way out of the serious trouble I was in…

THANKS AGAIN!!!



You have been like a mother for me…

Up to be seen, and thanks again!