Page 1 of 1
Posted: Fri Jan 17, 2003 11:09 am
by guitarcat
Hello everybody...big problems here!!!...i wanna use my yamaha 01v to control the stm 2448...i tried everything but nothing happens...can anybody give me a step by step introduction?...that would be realy great...i also tried it with the manuell...but nothing...please...!?...
thanx a lot
guitarcat
Posted: Fri Jan 17, 2003 11:33 am
by paulrmartin
there is NOTHING in the manual that talks about automation.
I have this Computer Music Magazine article which which talks about using the 01V as a controller. I will dig it out for you.
Stay posted
Posted: Fri Jan 17, 2003 11:45 am
by guitarcat
great man...thank you very much...
Posted: Fri Jan 17, 2003 12:11 pm
by paulrmartin
Check out this link!
http://www.c-mexx.com/english/5-downloads.htm
C-Console seems to have all that's needed to plug the 01V to anything you might have in your computer. MMC transmit is covered in the sync setup on the Toolbar.
I think I'm going to buy the C-Console!
Be sure to check out the How to tricks in the free downloads. Nice little animation video showing how to control the portamento of a softsynth. If you extrapolate, you can control your 2448 using the same trick.
_________________
Paul R. Martin - Are we listening?
<font size=-1>[ This Message was edited by: paulrmartin on 2003-01-17 12:21 ]</font>