Posted: Fri Jan 10, 2003 9:27 pm
I have an old Roland D-20 I wanted squeeze a little, I mean it's there anyway as my midikeyboard, why not use the sonic capabilities in it too. Therefore I decided to try out SoundDiver. But this didn't just work when I installed it. It just stalls and do nothing.
Then I read through the archive here on PlanetZ on the subject. It said something about the Creamware midiports being bad, that I had to raise the buffer but nothing specific about it.
So what is the story, can my Elektra card run Sounddiver? If yers, what do I have to do to make it work?
Cheers!
Thomas
<font size=-1>[ This Message was edited by: Petal on 2003-01-13 07:14 ]</font>
Then I read through the archive here on PlanetZ on the subject. It said something about the Creamware midiports being bad, that I had to raise the buffer but nothing specific about it.
So what is the story, can my Elektra card run Sounddiver? If yers, what do I have to do to make it work?
Cheers!
Thomas
<font size=-1>[ This Message was edited by: Petal on 2003-01-13 07:14 ]</font>