PlanetZ forums - scopeusers.com

Hi there!!!
I bought Powersampler card and after i update the software to Luna 2.5, after i bought the Luna 3 software and after some days ScopeFusion was out and i install it on my PC.

Im using a Pc:
Windows 2k with service pack 3
Pentium III 733 with 512 Mb ram
Cubase SX

The problem is that when i start the XTC mode and turn off SFP in Cubase Sx ther's no sound card available.
Can anyone explain me how can i use XTC mode with SX?
Do i need another sound card to audio output?
Is it possible to use XTC mode with my card only?
With my card witch is the best way to get best features? i don't need a sampler i need a good audio output and if possible use dsp effects on my produtions.
Please help this is really impotant cos i've been spending some money on creamware stuff but so far i'm not getting what i need from it, it was nice if i can use all features available.

hi,
i'm not xtc user, but maybe some questions can help.
did you install sfp with xtc features on?

do you have xtc mode enabled in your scope settings?

are you switching sfp off BEFORE you load cubase and did you select the asio drivers for cubase in the cubase device settings? these are the things to check to have xtc mode working.

i hope it helped you

ciao.

plus, there's some tips to get you started w XTC in... yes, the 'Tips & Tricks' forum.

Thankx mates.
Yes i've done it all but when i start Cubase with the SFP off ther's no device shown on Cubase, so ther's no audio output or Asio drivers to select is the same as i don't have a sound card, but when i start cubase with SFP on then everything is ok.