PlanetZ forums - scopeusers.com

When SFP launches I get this error:

SCOPE Fusion Platform: SFP.exe - No Disk

There is no disk in the drive. Please insert a disk into drive DeviceHarddisk2DR2


cancel try again continue


I hit continue 8 times then it launches pulsar



I get the same error when I select search options in the "set" pull down menu
except it only takes me hiting continue once to get to the search option config screen.


I updated from SFP 3.1b-3.1c


Can anyone help?


reply direct to dtwo@adelphia.net

http://www.dynamixii.com


Dynamix II

<font size=-1>[ This Message was edited by: dynamixii on 2002-09-24 00:57 ]</font>

I had the same problem with disk drive A
I think It has something to do with that I opend a file with the SFP filebrowser from a floppydisk . After that the browser is looking everytime to find the file.. I think in your case you should re-install.

good luck.
sorry for my poor English

Check CSET.INI file for a removable disk (a:/b: floppy, your CDROM, etc)...

If your project referenced ie: Sampler programs off a CDROM that isn't in the drive, I suppose that could cause this too. Suggestion in that case is to copy your Sampler programs to your HD (and reload them from there in your projects) so you don't have to flip-flop CD's in and out of your CDROM when you change projects.

I tried re installing

still same problem

Virtual Studio you are the winner

Thank you for solving my problem!!!

The No Disk error went away after I put a zip disk in my internal zip drive and looked at it in the SFP browser

Woo Hoo!!

Thank you Planet Z and Virtual Studio


David Noller


Dynamix II
Scratch-D vs. H-Bomb


http://www.dynamixii.com
http://www.zeroonemusic.com