PlanetZ forums - scopeusers.com

Is it possible? (and if so how can I do it) to 'monitor' the s/pdif input of the Pulsar in cubase? f.i. Route the s/pdif input to a track in cubase and mix it with the Asio channels? i.e. route it to the Cubase Master strip? (for applying a general NATIVE compressor on both asio and s/pdif in)

hi,
i´m no longer working that much with cubase as recording software but: it´s possible to route a signal through each input you have to monitor it. the main problem is that you will have an adding of latency when you send it out and then in to monitor it ...
to monitor it you have to activate softwaremonitoring in cubase. then you have to select the input (like always) and the push the little button "IN" in the cubase-mixer or in the parameterbox of the channel you want to monitor...

i guess that´s all...

good luck

t.

I tried that yertserday, but it gave me no sound at all