PlanetZ forums - scopeusers.com

Hi all,

I just bought me some optical cables to connect from my DAT recorder to my Pulsar II card. I can't get this to work so I thought "well I disconnect the cables and change everything back to it's original position". After doing this I keep getting the same message saying:

"Not all the selected devices in the current configuration were succesfully started with their selected options.

If this card is currently configured to accept a digital signal, and no digital signal is present, please either reconfigure the card to use an "internal" clock, or apply a digital signal, or if possible switch this port to accept an analog input."

I know when I still had the optical cables connected to the Pulsar card that I changed this setting in Cubase SX to "slave to SP/DIF". But every time I open up SX I can't switch to the ASIO Scope driver because I get this message every time.

I already tried to create a complete new project in SFP 3.1 but still it gives me this message. Can someone please explain to me what the hell is going on?

Thanks!

Acid

Did you set SampleRate back to master in SFP OS? I think you're in XTC mode now.

If it still doesn't work, have you tried feeding clock to the S/P-DIF again from your DAT?

Yep, did all that.

As I explained in my other thread I now do get a signal from the DAT but still it gives me the same error message...

I already re-installed V3.1 and created an entirely new project. But still it says that it's configured to receive a digital signal also when switching back to master in samplerate settings...

?????

Acid