PlanetZ forums - scopeusers.com

if i have the new pc here...
how should i install windows ,pulsar and logic ??

pulsar card --->win XP--->pulsar driver--->sfp3.1--->logic

or

winXP --->pulsar card--->driver --->sfp3.1--->logic

or should i switch between logic and sfp3.1 ?

do i have to disable sound on board ?
and when ? before winXP ?

thanks

<font size=-1>[ This Message was edited by: BoJoyce on 2002-09-14 23:06 ]</font>

Don't have much time now but http://www.planetz.com/forums/viewtopic ... forum=3&65, "Optimize Your Windows 2000/XP PC For Audio", will get you quite an end!

another question ..

if i want this new pc for use logic+pulsar only

....fat32 or ntfs do you reckon ?....

thanks

Well personally, I find that putting devices in after installing XP works quite nicely, it installs quicker for starters.

Secondly, I have found that sometimes that WinXp device detection can crash, if certain obscure devicess are present, whereas it works fine if I put it in after the main install.

For me, with my Pulsar I board recently, I have found that a reinstall of win9x operating systems seems to reset all my codes, requiring new ones from creamware.

(Creamwares FAQ say its to do with a fault with the Pulsar I board, reinsalling windows is for me when it seems to occur)

thanks

i still want more comments on NTFS

anybody ?

On 2002-09-17 11:19, BoJoyce wrote:
thanks

i still want more comments on NTFS

anybody ?

I think IMHO FAT is better for Audio performance than NTFS.

Snoopy

<font size=-1>[ This Message was edited by: snoopy4ever on 2002-09-17 11:43 ]</font>