PlanetZ forums - scopeusers.com

hi, i'm using cubase to monitor all the devices and mix them. my problem is that the channel settings are getting lost and i have to rentry them everytime i load the song..
(channel 5,6 to monitor input 1
7,8 to monitor input 2 etc...)
Another problem is that in a song the master output have dissapeared and everything is routed on bus 1...
and a last one.. can i record midi data on a selected channel and at the same time the audio channels which i use to monitor won't record???


thanx in advance

I mix the same way (check da tips 'n tricks "Bye-Bye Big Mixer" entry). I have found that Cubase likes to always have the same ASIO driver, including # of I/O channels. It seems that cubase 'remembers' the last driver used and tries to assimilate the next song to this ASIO channel map. I _always_ have 16 ASIO 2 ins and 8 outs. Also make your def.arr with exact driver configuration (including enabling all ASIO inputs and activating all buses). Do not have Cubase "open last song on start up."
I hope one of these fixes your prob. I have the same prob, but only if Pulsar forgets its ASIO driver (PCI bus probably) and Cubase devolves to an MME driver. . .

Well my settings are similar but when i open the song the second monitor channel is monitoring the third input instead of the second which it should... anyway it's nothing to reentry the settings only 8 more clicks.... maybe i click over 2 thousand a day!!!