PlanetZ forums - scopeusers.com

It seems that SPDif destination modules doesn´t works at 96Khz samplerate. Maybe this is happening because of the cables I´m using (analog audio cables). If anyone is using a 75 ohms cable (digital audio coaxial), let me know if the destination module works. By the way, I didn´t tried the source module.

Thanks

Why are you talking about "modules"?

Your card works fine in 96Khz Sample rate?

Try the input, and tell what happens...

DJATWORK

if your card is slave,you may need the source module.....

well, let me explain better.
I´m running both SFP 3.1c under XP and SFP 3.1a under 98SE. I have ROLAND DS-90a monitors and I´m using the SPDIF connection to feed them. The fact is that it works great with 44,100 or 48,000 Hz on both operating systems, but when I open the samplerate window and change to 96,000 Hz, the DS90a´s spdif light goes down and it stops to receive any signal. I´m using Belden high quality audio cables to do SPDIF connections and I cannot test SPDIF in because I don´t have any peripherals that outputs SPDIF. My LUNA is master(thats the only option in my case) and it works fine (except SPDIF) in 96K samplerate. So, If anyone have any idea...

Thanks!

<font size=-1>[ This Message was edited by: rafafredd on 2002-09-09 15:04 ]</font>

<font size=-1>[ This Message was edited by: rafafredd on 2002-09-09 15:06 ]</font>

<font size=-1>[ This Message was edited by: rafafredd on 2002-09-09 15:07 ]</font>

Well, i think that your roland ds90 don't accept 96khz as input, read your manual, and confirm.

well, you are right!!! It accepts 55K maximum. I was so certain that it worked at 96K that I didn´t checked it out. Sorry for the waste of time...

Are you shure that the Rolands DA is better than the CW DA?

CW has the better specifications that I had ever seen in AD/DA...

DJATWORK