PlanetZ forums - scopeusers.com

slight prob iv moved over to cubase sx......and cant get the asio scope drivers to function properly

my background project goes like this:

wave source into mini mixer then analog dest out

then pulsar adat source into asio dest (8 connections)

then pulsar asio source into adat dest(8 connections)


also pulsar midi source is connected to sequencer midi dest
and sequencer midi source is connected to pulsar midi dest

im using a yamaha 01v digi mixer which seems to be synced up fine

------------------------------
do i have to route the asio devices into the desk???

im losing it :0/

cheers
vinyl

The way you have this set up it looks like you are going to do all the mixing in the 01v??? (asio source -> adat dest). Is this what you want to do? Don't know why you are using a wave source sent to analog dest??

Me, I would set up as follows :-

1. ADAT source -> ASIO dest. This gets your 01v hooked up to cubase sx to record 8ch's. (also assuming you use the 01v to monitor)

2. ASIO Source -> STM Mixer (or whatever you use). This hooks up the output of cubase to the pulsar mixers for you to then to do mixdown add effects etc. Choose however many channels you need out of cubase. Also don't forget to activate the bus outputs in cubase.
In this setup you are using cubase merely as a tape deck, to record and playback.

3. Monitor output on mixer -> Analogue Dest. To hear what you are doing.


Again, this is just the way I would setup. I only use the sequencer software like a tape deck, to record and playback (and also automation). All mixing and effects I do in Pulsar.

Hope this helps a little to get you going?