Page 1 of 1
Posted: Sat Aug 17, 2002 6:44 pm
by mythalethe
I am hoping to upgrade soon from a 4 dsp Pulsar 1 to a newer card with lower latency. Does anyone know details about getting the ultra low latencies when using an old pulsar and a newer card? I think I can probably definately get low latencies with the newer I/O's, but am wondering whether there are any problems trying to use the old Pulsar I/O's in addition while still getting low latencies.
Thanks,
Mythalethe
Posted: Sat Aug 17, 2002 7:46 pm
by at0m
You have a first generation CW card now. If you add a second generation CW card, your system can tak the fastest interface of both. You will work with the combined IO's, DSP's and software.
I've worked w 2 Pulsar1's for a long time, then I added a Pulsar2 for it's ULLI, DSP's and IO's. Any combined CW hardware will work flawlessly as one unit. It's the easiest thing to do. Pick a card and off you go
<font size=-1>[ This Message was edited by: at0mic on 2002-08-17 21:34 ]</font>
Posted: Sun Aug 18, 2002 2:02 am
by mythalethe
Thanks Atomic!
I'm glad to hear that all the inputs will be useable!
-Mythalethe