PlanetZ forums - scopeusers.com

Hi,

I've been completely setting up my daw (again) and I almost got everything running...Almost.

I work with VST 5.1R1 and Pulsar II (V3.01) in combination with XP. I use the pulsar in XTC mode.

I still have two issues which I didn't have before and don't seem to get it fixed;

1. I only get output on the right channel using say a vst instrument. There is output on both left and right channels of the cubase mixer and I already switched cables (thus saying that I got output on the right channel). So this terminates the possibilty of a wrong setting on my mixer or a faulty cable.

2. I don't exactly remember anymore how to setup the wav source and wav dest modules in the pulsar project window. Before the new installation I was able to play back wav's via the pulsar card. Should I connect the wav source to the Asio dest driver? Or directly to the wav dest module? I tried both though however that didn't work.

Does anybody have a clue or hint?

<font size=-1>[ This Message was edited by: Acid Man on 2002-08-05 19:00 ]</font>

I already fixed issue two; had to connect the wav dest to the analog dest and the analog source to the asio2 dest module.

However... I still have the issue concerning the only right output. I tried to insert the left to the right input and vice versa in the pulsar project but still the sound is coming out on the right mixer channel

Hope this helps to fix the problem...

Cheers,

Acid

<font size=-1>[ This Message was edited by: Acid Man on 2002-08-05 19:47 ]</font>

...And also fixed the first issue (wrong output connected to the mixer cable). Ah well, let's just say it was about 3:30 in the morning...