PlanetZ forums - scopeusers.com

Posted: **Mon Jul 29, 2002 11:22 am**

Hi,

I use a Luna II with ADAT/ZLink-extensionboard and want to connect my a16 ultra via zlink. I bought standard firewire cables, installed the zlink i/o's, but I get no connection. zlink doens't appear in the XTC-settings, also in normal mode I dont get any signal to Cubase 5.1.

Are special cables necessary, where I can buy them in Germany, is ther a trick or so?

Thanks

Christian

Posted: **Mon Jul 29, 2002 11:37 am**

The Z-Link expansion uses power from motherboard for the breakout box. Do you have a power connector on your connection on IO board?

Posted: **Mon Jul 29, 2002 4:17 pm**

Oh, I have to control it, thanks!!

Posted: **Tue Jul 30, 2002 11:29 am**

The A16 does not require power from the PC. It has it's own power supply.

Did you get the 4 wire or 6 wire ZLink cables? (you need 6 wire)

Posted: **Tue Jul 30, 2002 11:35 am**

Also you must have the Zlink modules in your project...

Posted: **Tue Jul 30, 2002 4:45 pm**

On 2002-07-30 12:29, krizrox wrote:
The A16 does not require power from the PC. It has it's own power supply.

Did you get the 4 wire or 6 wire ZLink cables? (you need 6 wire)

I don't know, I hav to measure it...

Thanks

Christian