Page 1 of 1
Posted: Fri Jul 26, 2002 1:57 am
by DJATWORK
I feel a little stupid because I can´t really make the Vocoder2 make any sound. I had read the manual several times, and tried anything, but I cant make any signal appears in the "out" vumeter.
any idea? Thanks!
DJATWORK!
Posted: Fri Jul 26, 2002 8:57 am
by at0m
do you feed audio into both S & A? Unlike some other Vocoders, CW's vocoder does not have internal synth generator. (or did that come w SFP Vocoder?)
Posted: Fri Jul 26, 2002 7:55 pm
by DJATWORK
It should be an installation error, or a bug or something like that. I´ll try to reinstall it, and then I´ll see.
Thanks a lot!
DJATWORK!
Posted: Sat Jul 27, 2002 1:48 am
by at0m
If you don't get any warnings when you load the voco, there should be no install faults...
Posted: Sun Jul 28, 2002 4:11 pm
by DJATWORK
Now that you say that, I think that it might be an installation error, because several warning messages appears when SFP starts. I had installed several times, formating and making a new clean install of the OS and always appears diferent warning messages. ALmost them say that one or other effect isnt correctly installed...
Do you have the same problem?
Posted: Mon Jul 29, 2002 11:32 am
by subhuman
Hmm, I would say obtain a copy of SFP 3.1a (not just 3.1) and reinstall. You shouldn't get any errors when SFP loads or your install has issues that a reinstall will likely fix.
Posted: Tue Jul 30, 2002 4:08 pm
by at0m
Posted: Tue Jul 30, 2002 7:18 pm
by DJATWORK
at0mic thank you very match!!
the link to the vocoder example, doesn´t work, but I´ll keep trying!!
THANKS!!!!
DJATWORK
Posted: Wed Jul 31, 2002 10:41 am
by subhuman
Link updated.
