Posted: Wed Jul 10, 2002 4:48 pm
hi everyone
i have just installed 3.1a software to my Pulsar 1 + SRB board.
when i export a cubase track that uses XTC synth or effect i get corrupted result (sound is phased and looses most low & mid frequencies). any suggestions?
is there a way to record XTC devices within cubase ? how do i route it to the cubase input???? (i'm using cubse 5.1 - will SX have any advantage in that aspect?)
Is there a way to monitor Pulsar Analog Sourse while in XTC mode ??
i have just installed 3.1a software to my Pulsar 1 + SRB board.
when i export a cubase track that uses XTC synth or effect i get corrupted result (sound is phased and looses most low & mid frequencies). any suggestions?
is there a way to record XTC devices within cubase ? how do i route it to the cubase input???? (i'm using cubse 5.1 - will SX have any advantage in that aspect?)
Is there a way to monitor Pulsar Analog Sourse while in XTC mode ??
