Page 1 of 1
Posted: Sat Apr 21, 2001 8:08 am
by bosone
Excuse me, but i cannot change the program in the pulsar synth....
i open the preset list, give a number to a patch and then, when i try to recall it by a program change (form my external keyboard or by cakewalk), nothing happens.
i also see the midi data coming on the light of the device, but, again, nothing!
the manual doesn't say anything about this topic
WHAT MUST I DO!?!?!?
Posted: Sat Apr 21, 2001 11:12 am
by MeloManiac
Save the device first....
Posted: Sun Apr 22, 2001 2:01 am
by bosone
i did!!
the very strange thing is that, if i open the modular, i see in the MIDI window (the one that show the incoming messages): PRGR CHANGE !!!!
so the message arrives, but it not interpreted!!!
!?!?!?!?
Posted: Mon Apr 23, 2001 2:48 am
by Zer
Did you cable the sequencer midi out to your pulsar synth or just your master keyboard?
Posted: Mon Apr 23, 2001 8:18 am
by bosone
i tried both: the pulsar midi in (physical one) to the synth for trying to change with the masterkeyboard, and the midi source(software one) when i tried to change the bank from the sequencer.
i have pulsar ver. 2.04 is there some bug? i mailed alo to CW, and i'm waiting the answer!
Posted: Mon Apr 23, 2001 11:23 am
by subhuman
Pulsar synths don't reliably respond to program changes. The STSx000 samplers do though!
Posted: Thu Apr 26, 2001 7:44 am
by Zer
hmm...if I use the original synths by creamware, they do! It takes just a lot of time until the setting has been changed. By the way which sequencer are you using? Sometimes Logic doesn´t correspond with the synths so you´ve to change the environment from logic to your needs. However within Cakewalk all the p-changes worked without configurations except from assigning the program changes in the pulsar synths.
Posted: Thu Apr 26, 2001 11:08 pm
by bosone
i use cakewalk. i tried every synth i have, but i get no answer when i send a program change. very very very very strange.
BTW: i sent also a mail to CW asking for help, but they didn't anwser yet