Page 1 of 1
Posted: Sun Jun 16, 2002 10:56 pm
by pebre
Any experience with setting up a luna or pulsar environment with a amt8 midi interface? Need I do somethinh special in the project window or is this just simple install and use?
Posted: Mon Jun 17, 2002 12:01 am
by at0m
When working with a patchbay, it might be easiest to control all SFP devices via the patchbay.
This offers 2 main advantages:
-all midi devices will 'suffer' same latency, cos the midi they receive is sent by the same device w the same drivers,
-and you avoid using CW midi drivers, CW's hardware ports are simple better
Posted: Mon Jun 17, 2002 12:02 am
by at0m
(so connect the patchbay to Pulsar hardware midi source/dest)
Posted: Mon Jun 17, 2002 12:14 am
by pebre
So what you say is: don't connect the patchbay via usb to the pc but use it via the CW midi device.
But what's the use of a pc oriented patchbay then? this way I can't choose in Cubase which midi in/out I want to use, correct?
I can only use the CW midi in/out
Posted: Sat Jun 22, 2002 1:01 pm
by six_wax
I think what he means is:
PC -[usb]-> AMT8
AMT8 -[midi]-> P2 Midi Hardware
I'm about to try this with my serial Midisport...
Posted: Sun Jun 23, 2002 8:46 am
by krass
Just use the physical midi-ports on your card to connect to a port on the AMT.
I do the same with the Steinberg Midex-8, and it works fantastic. A major improvement compared to when you go through the OS.
Regards,
KrasS
Posted: Thu Jun 27, 2002 3:52 am
by pebre
Connected the AMT8 via serial port, usb didn't work.
Connected the luna midi ports to the amt8 so now I can also play VSTi's on my masterkeyboard.
Everything works just fine.
thanks to you all for your reaction