Page 1 of 1
Posted: Fri Apr 20, 2001 6:27 am
by marko_jelic
I've got ASUS CUL2 MoBo which has six PCI slots. I only use two of them; Pulsar I and SCSI Card. Now the qoestion is why did computer asigned both to the same IRQ# (5)and is it possible to manualy asign IRQ# to specific device. Also, does it mater which PCI slot is used(Pulsar is on first, the closest to the AGP slot and SCSI card is on the last). Thanx, marko
Posted: Fri Apr 20, 2001 6:52 am
by fevertrax
as far as the slots go...the pulsar manual says not to use the first or the last one (something to do with defaults, i am too lazy to go reas it now), so don't do it...same irqs, they say, are allowed though in most cases though.
Posted: Fri Apr 20, 2001 2:27 pm
by John Cooper
see <a href="
http://www.planetz.com/Pulsar/MultiPulsarPC.html">this article</a>. it may have some useful info for you.
<font size=-1>[ This Message was edited by: John Cooper on 2001-04-20 15:28 ]</font>
Posted: Fri Apr 20, 2001 5:28 pm
by gregor
I just bought the same board and took a closer look in the bios. It IS possible to manually assign any IRQ to any speciffic PCI-slot (watch out while some slots share the same IRQ), also in your Asus booklet is explained exactly how to do that...
Posted: Sat Apr 21, 2001 11:02 am
by subhuman
Slots 1+5 are a great choice for 2 Pulsar boards on the CUSL2 since they share.
Slot 2 can be totally unshared on the CUSL2. With one card, this might be a good one to use, such that the heat from the video card doesn't heat up your CW card.
Posted: Mon Apr 23, 2001 3:36 am
by marko_jelic
thanks for the inputs guys, marko