Page 1 of 1
Posted: Wed Jun 12, 2002 8:56 pm
by oneartist
1. I unzipped SFP 3.01a to an empty folder named SFP.
2. I unzipped Modular 2 to the same folder
3. I installed 3.01a and imported the key set for Pulsar
4. When I tryed to start SFP I got the mess "Please close ..."
5. Next I tryed uninstalling Pulsar 3.01 but I still get the message
What am I doing wrong?
Chuck
Posted: Thu Jun 13, 2002 12:23 am
by garyb
sfp is already running on the taskbar right?
Posted: Thu Jun 13, 2002 1:20 am
by Tony B
This was dealt with already by Subhuman. Right click on SFP icon in the Tray and click on show.
Search the forum before posting questions.
Posted: Thu Jun 13, 2002 5:02 pm
by oneartist
garyb, yes it is on the task bar and abre11 answered my question. And for abre11's comment about me not searching the forum, I did search the forum but I didn't see it. Just a simple R click tip was all that was needed. Thanks,
Chuck
Posted: Thu Jun 13, 2002 7:02 pm
by bc
Unless of course you're using Win XP and are using more than 8 Wave Devices. Then SFP does not appear in the Taskbar at Start up. If set to run at startup you have to use Task Manager to End Task then re-start SFP. From then on it appears in Task bar. I just don't load it at start up and do it manually.
Posted: Sun Jun 16, 2002 2:45 pm
by alfonso
<font size=-1>[ This Message was edited by: alfonso on 2002-06-16 15:48 ]</font>
Posted: Sat Jul 06, 2002 5:36 pm
by fortner
[quote]
On 2002-06-13 20:02, bc wrote:
Unless of course you're using Win XP and are using more than 8 Wave Devices. Then SFP does not appear in the Taskbar at Start up. If set to run at startup you have to use Task Manager to End Task then re-start SFP. From then on it appears in Task bar. I just don't load it at start up and do it manually
Oh, in my WinXP-Sytem (Luna II + Pulsar SRB, 16 Wave devices) with SFP 3.1a it works fine and it appears in the taskbar.
Bye
Christian
<font size=-1>[ This Message was edited by: fortner on 2002-07-06 18:37 ]</font>