PlanetZ forums - scopeusers.com

I have two Pulsar-3.1-Installations (Win98 and WinXP). In Win98 (XTC-Mode) everything works fine. I get Midi-Input-Signals and can send them everywhere (Synths etc.).
When I start Cubase under WinXP (Pulsar in XTC-Mode)I cannot get any Midi-Signal at all. I cannot play any synth. The Cubase-Midi-Indicators don't show any activity.
In both cases I use the same XTC-Project. Did anybody encounter the same problem? How did you solve it?

Yes I have a similar problem,but I don´t know how to solve it.The midi works in Sampliude but not in cubase. have the idea
that it has to with the new asio drivers.

Kim

Try removing and reloading your midi source and save the file.
I had the same with logic audio . After a clean install in win98. In winxp i don't know cos i still use win98 for audio cos i do not get sfp to work perfectly in xp jet.

Laterz

XP: load always as many midi source/dest's as assigned to your hardware in Device Manager.

Now my midi works again in cubase (thet worked all the time in Samplitude.I removed 3.1 drivers and replaced them with 3.01(win2000 drivers).3.1 can`t be installed on my system anyway.

Kim