Page 1 of 1
Posted: Thu May 23, 2002 3:36 pm
by Lugian
Required hardware in the SFP docs doesn't mention Pulsar 1... has anyone with a Pulsar 1 made it work, or should I stick with Pulsar v3 software ?
Thanks
Posted: Thu May 23, 2002 4:29 pm
by thermos
i got a luna2 board with pulsar 1 and pulsar1 srb it works fine.
the sfp is registered to my srp card so i dont think there will be any problms.
thermos
Posted: Thu May 23, 2002 5:48 pm
by Lugian
Thanks thermos - a glimmer of hope.
I don't even have a SRB card though: just a Pulsar 1 purchased in early 1999. Anyone else got "only" that card and got SFP3.1 on it ?
Thanks again
Posted: Thu May 23, 2002 6:18 pm
by algorhythm
yes it works
Posted: Thu May 23, 2002 6:39 pm
by Lugian
Thankyou
Now to start the download...
Posted: Thu May 23, 2002 6:56 pm
by wayne
Ancient and venerable card loves new software
Posted: Thu May 23, 2002 7:09 pm
by garyb
pulsar1 and two pulsar1 srb's no problem.