PlanetZ forums - scopeusers.com

Hello All,

Here's what I'm looking to define. I wasn't able to find this information out and fell upon something odd while trying to install my new system this week-end. Please help me out here.

I have a Pulsar I and a Scope I card. The Pulsar is a classic and the Scope has the ADAT 24 I/O with Syncplate and the 3MIDI I/O plate.

Does the Pulsar I/Scope I support the ASIO 2.0 64 module in Creamware? When I loaded that module and then tried to load Cubase, Cubase told me that it couldn't find the ASIO. So could we create a device matrix that says for each of the cards, what ASIO drivers to use?

My thoughts are that the ASIO 2.0 64 module doesn't work or isn't meant to work with my older setup but I might be wrong. When I set it on the regular ASIO things are fine. PLease advise.

Just wanted to let you know, I did print out the manual. I'll try keepin everything 16-bit with my ADATs and see what happens.

_________________
Ravenwhite Productions
Digital Recording Studio
Milwaukee, WI USA

<font size=-1>[ This Message was edited by: ohmelas on 2002-05-20 03:20 ]</font>

Let's do it in this format:

List the modules from CW that are supported by Pulsar 3.01 software or SFP 3.1. Specifically speaking I would like to know wich of these modules work on generation I vs. generation II hardware! The manual wasn't specific about all of them. A nice matrix would be grand huh?

32 & 64 channel ASIO In/Out 16, 24 & 32 bit

32 & 64 channel ASIO2 In/Out 16, 24 & 32 bit

16 channel tripleDAT In/Out

32 channel GigaSampler Interface In

16 channel Wave Interleaved driver In/Out


Multiple stereo Wave In/Out, 16 & 24 bit

Multiple Sound Manager In/Out (Mac)

DirectSound In

Digital Wave Source (for AC3 Surround)

Sound Card(s) In/Out

What support does each of them have?


<font size=-1>[ This Message was edited by: ohmelas on 2002-05-20 03:41 ]</font>