Page 1 of 1
Posted: Thu May 16, 2002 9:15 am
by Tony B
I have installed two Luna 11 in my PC. I am seeing six DSPs. GOOD but I am getting errors like "not enough memory", Logic is refusing to launch and no STDM cable detected. I cannot select "Import audio file". No audio track selected. Any help???????
Posted: Thu May 16, 2002 9:29 am
by subhuman
So you can see 6DSPs now.. but can you load them all full? If not then close your CW app completely (including tray), backup your "dsp.idx" file, and then remove it, and reload CW app.
Posted: Thu May 16, 2002 10:10 am
by Tony B
I don't have an STDM cable attached. I should be getting one in about a week. The DSPs cannot be loaded full. Where do I find that DSP.idx file? Thanks. I received a mail from Creamware a while ago saying that the cards would not work without the cable.
Posted: Thu May 16, 2002 10:15 am
by subhuman
Well you shouldn't have even INSTALLED the second card without an STDM cable!!!!
Posted: Thu May 16, 2002 10:56 am
by Tony B
OK. I guess i'll have to wait on the cable.
Posted: Thu May 16, 2002 6:58 pm
by algorhythm
On 2002-05-16 11:10, abre11 wrote:
I am getting errors like . . . no STDM cable detected.
I received a mail from Creamware a while ago saying that the cards would not work without the cable. I don't have an STDM cable attached.
dsp.idx is in pulsar/app/dsp - but I wouldn't bother deleting it now, your problem is a bit more physical. Pull out that second board, sit tight, and wait for the post man to show up with yer cable
Posted: Fri May 17, 2002 1:16 am
by Tony B
Thanks. I can't wait. MORE DSPs AND MORE DSPs
