PlanetZ forums - scopeusers.com

I have this problem with the arpeggio sunth...how do i get it to work properly.... tried to connect it in a project but im doing something wrong....HOW shall it be connected?

The Arpeg01 is not a synth in itself. It´s used to arpeggiate synths. For instance if you play an a-minor chord on any synth, you can get the arpeg01 to play the tones in the chord one by one, and many different ways. (from higher to lower octaves etc. just experiment)

There a different ways to connect the arpeg01, but i use this setup (witout a sequencer)

PulsarMidiA Source out
connected to
Arpeg01 Midi
connected to
(any Synth)Midi
connected to mixer etc.

When using a sequencer I´m not quite so sure how to do it, but someone here knows. Anyway there is something on Arpeg01 in the manual, check it out.

Hi Redix,
connect the midisource to the midi in and the midiclock of the apregg..
Than connect midi out from the apregg. to midi in of the synth you want to use with it.
If you want to use the apregg. in sync to your sequencer(midiclock), switch the external midi clock botten on in the tempo area of the apregg..
If you do it the botten is yellow.
Don't forgett to send midiclock from your sequencer to pulsar.
Thats all.
Hope that helps.
Maybe i got the manual of the apregg. i must look.
When i'll find it i can send it to you.
When not ask in the forum maybe there are some old users of that dev. and i think somone can send it to you.
Good luck and have fun with it
Tomas M.