PlanetZ forums - scopeusers.com

i had the famous PCI overflow error... expecially when i were using a reverb (also in very simple projects) and there was no chance, even by lowering MaxPCchannels parameter, as suggested in the manual
NOW i downloaded and installed the latest driver VIA 4in1 that you can find at asus website.
THINGS ARE GOING VERY VERY VERY WELL!!!! i was able to run a complex project (mixer+effects+reverb) while playing from cakewalk and gigasampler and recording the mixdown in soundforge!!!!
Good luck to all!

Can you load a BigMixer, STS4000 Sampler (8 or more voices) and a Timeworks EZ/4080 Verb?

That's the true test, a basic workhorse project for a PulsarI. I have yet to see it work on a KX133 chipset (I'd say impossible), but heard a few people were lucky enough to get it working on a KT133.

Which reverb are you using? Cos the stock Creamware one doesn't push the PCI bus very much.

i'll try soon and tell you!
i'll use timeworks ezverb. the last project was with the miniverb.
stay tuned!

the test was OK!
i used STS3000 with 32 voices of poliphony (8 instruments at once), timeworks ezverb (the only onw commercial plugs i have) and a bigmixer.

Now add another EZVerb, or a single Delay effect with everything you already have loaded, loaded still. The delay may fit, but I bet it pukes on the second EZVerb.

How many audio channels are you able to stream off your harddisk with the BigMixer+EZVerb+STSx000 (16+ voices)? On my CUSL2, I am able to run 38 (different) audio channels (.WAV) off my 7200RPM HD, with these devices loaded.

Try that and report back :]

It didn't work, did it?

( you won!
but for now i've no money to change my mobo....
still i'm happy because, at least, i can use ONE reverb, and perhaps all the owner of via kt133 now can!