Posted: Thu Apr 18, 2002 10:53 pm
I think this is impossible to solve, but is there any way you can open a new Pulsar project without Cubase goes mad as the ASIO drivers disappears for a while?
Cheers,
Carl.
Cheers,
Carl.
PlanetZ forums - scopeusers.com
Scope Users Community
https://www.forums.scopeusers.com/
ASIO error while changing projects
Page 1 of 1
Posted: Thu Apr 18, 2002 11:11 pm
Yup. I simply ignore the popup untill the project is loaded, then click 'Proceed' in Cubase
Posted: Fri Apr 19, 2002 12:25 am
Aah... that was a bit too obvious for me. I was thinking of doing some hardcore registry-hack... 
Thanks,
Carl.
Thanks,
Carl.
Posted: Fri Apr 19, 2002 3:05 am
me too, but i think that's better to close cubase while changing project to avoid this error messages!?On 2002-04-19 00:11, at0mic wrote:
Yup. I simply ignore the popup untill the project is loaded, then click 'Proceed' in Cubase
Posted: Fri Apr 19, 2002 5:40 am
You can disable audio in Cubase while you switch Pulsar projects, then re-enable.
/dave
/dave
Posted: Fri Apr 19, 2002 6:02 am
ha! cooool tip!!On 2002-04-19 06:40, dbmac wrote:
You can disable audio in Cubase while you switch Pulsar projects, then re-enable.
i just assign key commands to "D" for "disable/enable audio".