PlanetZ forums - scopeusers.com

Hi all.
I know this is a bit dumb, but i want to run my midi keyboard into cubase.
What settings do i have to put in Pulsar project window and then i cubase?

My keyboard is hooked up to Pulsar 2 MIDI A.
Ideally i want it to run Roland Virtual sound canvas (MP1). I am lost... Any help would be really appreciated.
(I also have my SBLIVE card in)

PIII 1000
256MB
ASUS CUSL2
PULSAR II (PP)
SBLIVE!
20GB 7200

cheers

to send midi to cubase you have to connect pulsar(2) midi source to sequencer midi destination. if you do so you should see on the right of cubase transport bar the lights of midi signal blink when you play notes.
to play vst instruments you have to select midi track output. you will find in the inspector all the outputs available. of course you will have those related to vst instruments only if you select them in the vst instruments panel.
to play pulsar synths you have to select the creamware midi out, that should be selected by default and connect sequencer midi source to the pulsar synth.
but everything is clear in the manuals.
ciao, alfonso.