PlanetZ forums - scopeusers.com

I would like to ask if someone could duplicate a problem I am having. Take the Pulsar analog in and patch it to a Dynamic Mixer ch1 set to mono. Insert a Compressor M into the first slot and the PEQ4 M into the second slot. Patch the Dynamic mixer out to Pulsar analog out(for monitoring duh). If you hear sound you don't have the same problem. If you have to put the PEQ4 M in bypass to hear sound then you have the same problem I just ran across. Look out it could be a BUG!!!

kaptain karl

maybe there is a problem with the "mode" (lowshelving-low pass etc..) of each point in the parametric eq is set
check the points and it should work

<font size=-1>[ This Message was edited by: fra77x on 2002-04-03 03:52 ]</font>

Well if I go back after and change one point it then will pass audio thru again. I'll just shrug my shoulders and go about making noise.