PlanetZ forums - scopeusers.com

I use a Dual Screen Setup (Matrox G450 PCI) and run Pulsar in OS mode. (system: XP, Pulsar V3_01)

The Project Window and the File browser are on my 2nd screen but my taskbar isn't. It only appears if I move my windows-taskbar to the top of the 2nd screen.

I tried the Pulsar-mode but then Pulasr is on my 1st screen and thats where I want Cubase. I also tried to switch between dual/singel screen but that doesn't change anything.

Anyone??

Thank You!

You can move the Pulsar Taskbar by grabbing the bar where 'Creamware' is written. Put it somewhere where it's not under your computer OS' taskbar.
Sometimes there's errors w the dropmenu's not coming into view, simply drag the bar to other side of the window.

On 2002-03-20 14:16, at0mic wrote:
You can move the Pulsar Taskbar by grabbing the bar where 'Creamware' is written. Put it somewhere where it's not under your computer OS' taskbar.
Sometimes there's errors w the dropmenu's not coming into view, simply drag the bar to other side of the window.

Well, the problem is slightly different...
When I start Pulsar I don't have my Pulsar taskbar at all! I do have my projectwindow and filebrowser on my 2nd screen.
But when I move my Windows taskbar to the upperside of my 2nd monitor (where normally the Pulsar taskbar is) then suddenley the Pulsar taskbar appears.
So the question should be: where is my Pulsar taskabr at startup?

Thanks for your reply so far!