Page 1 of 1
Posted: Sun Mar 17, 2002 8:53 am
by Valium
Hi there
Is there a way I can use my old luna II mixers and stuff in my new setup (Pulsar I and Luna II) if yes how?
thx in advance
Posted: Sun Mar 17, 2002 9:02 am
by at0m
Just load the device, but make sure you got it on disk. If it's registered to a card which isn't registered yet, PulsarOS will ask you for your card and key.
Posted: Sun Mar 17, 2002 9:02 am
by at0m
Just load the device, but make sure you got it on disk. If it's registered to a card which isn't registered yet, PulsarOS will ask you for your card and key.
Posted: Sun Mar 17, 2002 9:51 am
by Valium
Hi thx for the reply,
I was wondering, if I copied all my old luna devices into c:pulsar3devices.. could this make it a little easier on myself?
Just thinking of the easiest way to gain acces to old devices / projects.
Will this work if I do the same with my old projects?
thx and greetz
Posted: Sun Mar 17, 2002 9:56 am
by at0m
Hi West-side
Yup, just make a folder "Luna2" like there's a "Pulsar2.04" folder in the "Devices" folder.
For projects I don't know... (I don't have Luna)