PlanetZ forums - scopeusers.com

Hi mates i have recently added a PowerSampler to my Pulsar 2 using STDM cable under Windows XP.
After that,the midi drivers of Pulsar and of my midi interface ego-sys MIDITERMINAL 4140 are disapperead (on SONAR check MIDI DEVICES and nothing appears...).
What's happened?
Anotha question...what i must do to enter the key of the STS-3000 that i have buyed with the PowerSampler without reinstall all the Pulsar software?I know re-installing the pulsar software u can enter the STS-3000 key after the board's key,but,i don't want to make a complete reinstall...there's anotha solution?
Thanx a lot.

http://web.tiscali.it/kwild



<font size=-1>[ This Message was edited by: kwild on 2002-03-13 17:28 ]</font>

<font size=-1>[ This Message was edited by: kwild on 2002-03-13 17:36 ]</font>

Im going crazy...
I've reinstalled a lot of times the pulsar drivers,removed pulsar 2 and powersampler from the case,deleted all creamware entries on regedit but nothing!
Still no midi devices/ports.
All midi drivers (sequencer dest/source,pulsar physical midi ports) and the midi ports of my MIDITERMINAL are gone!
Only the serial roland midi driver for my CS1X connected to the serial port seems to work...and the microsoft midi mapper is the other midi driver still working.
It's a very strange problem...please somebody can help me?

Check Pulsar's driver settings in DeviceManager. It may be that you have 0 (zero) midi ports selected there.

no mate is not so simple...
sorry...

Problem solved.
It was a direct x problem i've reinstalled windows over the old installation and all seems to work fine.
Yup!