Page 1 of 1
Switching speakers ?
Posted: Mon Sep 30, 2024 12:20 pm
by nebelfuerst
I'm looking for an easy solution for a easy problem:
There are 4 speakers in my room, located in each edge of the room, like this:
1 2
3 4
Sometimes I'd like to have 1&3 to be left and 2&4 to be right.
Sometimes I wand 1&2 to be left and 3&4 to be right.
Switching should occur by a single mouseclick.
Is there a elegant way to get this done ? (Without midi automation.)
Re: Switching speakers ?
Posted: Mon Sep 30, 2024 3:11 pm
by mausmuso
Hi,
Did you mean from within Scope? or externally.
I have built a few switching devices that would likely do what you are asking.
Below are couple of examples.
I can upload them if you wish?
maus
- SpkrSwitching.png (138.32 KiB) Viewed 11045 times
Re: Switching speakers ?
Posted: Tue Oct 01, 2024 8:50 am
by Spielraum
nebelfuerst wrote: Mon Sep 30, 2024 12:20 pm
I'm looking for an easy solution...
check
Swap Example |MODULES #Spielraum
>BC4x4Speaker-SR20241001a01
mausmuso wrote: Mon Sep 30, 2024 3:11 pm
SpkrSwitching.png
cool maus, please upload to devices, thx
Re: Switching speakers ?
Posted: Tue Oct 01, 2024 7:10 pm
by Bud Weiser
Spielraum wrote: Tue Oct 01, 2024 8:50 am
cool maus, please upload to devices, thx
It´s here ...
viewtopic.php?t=37877
Bud
Re: Switching speakers ?
Posted: Wed Oct 02, 2024 7:24 am
by nebelfuerst
The BC4x4Speaker-SR20241001a01 is exacty, what I was looking for. ThnX a lot !
Stereo switch4 is also in my setup, but for switching speakers to headphones. A 2nd ThnX for that !