PlanetZ forums - scopeusers.com

I would like the tempo delay in ModV2 to be triggered by a waveform such as squarewave so that I could trigger two delay values one long one short in a wave pattern.
Or use a sine wave to get a sweeping range of delays between maximum and minimum values.

The problem I have at the moment is that I try to connect the freq of the left and right delays to the freq divider and the input of the freq divider to an lfo I get division by zero errors (quite rightly so)
I can understand that I need to raise the freq so the oscillation values occur above the zero value although I am at a loss as to how to do this. Ideally I would like to be able to specify the range through which the oscillation occurs and which waveform to use.

I'm writing this as I get out of bed, so my brain might be messed up... It seems, you'll need to find a way to add a constant value to the waveform. Never tried this myself tho. So you'd want to make it a unipolar value, instead of bipolor (of mod2 terms I think). Theoretically, adding a constant 64 should do the job, if the lfo sweeps from -64 to 64. Or, if you don't want a zero, a 65. Does that make sense??
But I sort of understand what you're trying to do.. I do it all the time on Nord Mod.

<font size=-1>[ This Message was edited by: kensuguro on 2002-02-05 16:21 ]</font>

Cheers friend, that is exactly what I was looking for. Many thanks

It's amazing what you can do when you are just rolling out of bed

<font size=-1>[ This Message was edited by: Marlin Spike on 2002-02-05 22:11 ]</font>