PlanetZ forums - scopeusers.com

I have a powersampler with Luna V301 drivers. Seems to work ok under win 98 accept when I save a project, (lets say an sts3000 with a few samples loaded, masterverb and a delay fx etc) and then reload it the next day, the fx don't work. They appear in the mixer and all the settings are as I left them, but no actual sound passes through. The input level meter on the masterverb is dead.

But, if I remove the module and then reload it, it starts working again. This is also the case with any insert fx. Most annoying.

Am I missing something stupid or is there a genuine problem.

Cheers
Gyp

I encounter that phenomenom too... I put the fx in the auxiliary (internal), and each time I reopen the project, I have to click on the button which specifies if the plug-in is internal or external, in the auxiliary control surface... If you load your fx there, you only have to reset this function to have it alive again, without reloading it!

This should be fixed anyway by the company...