Page 1 of 1
Posted: Mon Jan 28, 2002 7:56 pm
by JD
how do i permanelty save my controller change 74 that it is mapped to my filter cutoff so that i don't have to remap again later. i know i could do this in v2.01. doesn't seem to be supported in v3. big hassle to have to remap everytime i load the device.
cheers JD
Posted: Mon Jan 28, 2002 8:57 pm
by topaz
maybe it will be fixed in 3.1
for now the only way I see is to set up ccr's for each project.
I asked the same thing here
http://www.planetz.com/forums/viewtopic ... &forum=1&6
On 2002-01-28 19:56, JD wrote:
how do i permanelty save my controller change 74 that it is mapped to my filter cutoff so that i don't have to remap again later. i know i could do this in v2.01. doesn't seem to be supported in v3. big hassle to have to remap everytime i load the device.
cheers JD