Page 1 of 1
Posted: Thu Dec 28, 2000 4:49 pm
by gelder
hi,
can i run elektra software on pulsar ii card ?
Posted: Thu Dec 28, 2000 10:55 pm
by Guest
Subject: (yes)
Elektra software is basically, the Modular II, so yes you can buy Modular II for Pulsar II ... it even come for free after you register your card(not sure if it's still valide).
And of course if you currently have an Elektra card and plan to buy a Pulsar II , you Elektra software could be used "within" the Pulsar soft.
Rgds
zdar
www.funkelectric.com
Posted: Fri Dec 29, 2000 8:37 am
by gelder
Subject: elektra
thanks
i downloaded the elektra software from CW site , it still there...
Posted: Fri Dec 29, 2000 7:37 pm
by Guest
Subject: Re: elektra
WEll, you have downloaded it, fine, but does it install????.
Posted: Fri Dec 29, 2000 8:19 pm
by Guest
Subject: elektra
didn't try it yet , but as soon as i will , i'll tell ya.
Posted: Sun Dec 31, 2000 9:22 am
by RoonSmits
Subject: Electra on PowerSamper Card
Well I downloaded the full +120Mb for the Elektra but this doesn't work on my POwerSampler although it's as far as I know the same hardware. The only thing I can think of is that the "Key" which you have to enter during install is verified somehow.
Best regards
Ronald