Page 1 of 1
Posted: Tue Jan 22, 2002 6:30 pm
by kiminet
I just got a new problem.A terrible noise followed by "burning needle forrest" sound come now and then.
It happend both with asio and wawe drivers.After that there is no sound before I reload the project.
I just installed a Pulsar1+ which was use for demo in a shop.Now I have pulsar 1 and srb and pulsar puls all on the same IRQ.
I have a brand new asus culs2c 1GHz .Does anyone have experience with this problem.
It sounds like sick hardware doesn´t it?
Kim
<font size=-1>[ This Message was edited by: kiminet on 2002-01-22 18:30 ]</font>
Posted: Tue Jan 22, 2002 6:42 pm
by subhuman
Or a digital clocking/sync error... what other gear do you have physically connected to your cards?
Posted: Tue Jan 22, 2002 10:28 pm
by kiminet
Thank you.
That is absolutely possible since I most of the time sync to either sp/dif (TC M2000) or adat (converters).In fact one time I solved the problem by syncing to pulsar.Would it be more safe to use AES/EBU from M2000?
Kim
Posted: Tue Jan 22, 2002 10:49 pm
by at0m
If you have EBU on both -go for it!! If not, you have to look for the most stable clock in your chain. Play with Master/Slave settings, it might bring clarity. If it's clock related.
Posted: Wed Jan 23, 2002 11:37 pm
by kiminet
Unfortunatly it must be a defect board.I deinstalled it and every runs fine for hours.
Kim
Posted: Thu Jan 24, 2002 12:31 pm
by kiminet
Ok.I checked the card alone in the computer and that worked.So the cart is ok.I think it could be the way I distibuted the carts in the PCI slots that caused the ugly sounds.
Could that cause bad sync inbetween the 3 carts?
Then
slot 2 pulsar1
3 pulsar 1+
4 scsi cart
5 SRB
NOW
slot 2 pulsar1+
3 pulsar 1
4 SRB
5 SCSI
Posted: Thu Jan 24, 2002 12:45 pm
by subhuman
On CUSL2:
Use Slots 1+5, force their IRQ in the BIOS, connect via STDM. Remember to reinstall the drivers/software after physically moving the cards around.
If you have 3 cards, use slots 1+2+5, and force 1+5 and 2 to share an IRQ in the BIOS.
Posted: Thu Jan 24, 2002 3:40 pm
by kiminet
Thanks.I`ll try that,but I was always told than it´s no good to use slot 1 because it conflicts with the grafic cart.Isn´t it like that on Tuls2c (my board)?
Kim
Posted: Thu Jan 24, 2002 4:07 pm
by subhuman
All motherboards/chipsets provide different slot/irq sharing relationships so such a rule doesn't really have any bearing on reality.
Yes, the way I describe it will work perfectly on your board... worked for me and 100s of others.