PlanetZ forums - scopeusers.com

Above all, I want to say HELLO to my old Pulsar Community. I have been without Internet for months and had to get into a Café sometimes, to see what was going on, but it’s expensive. It’s not the same having it at home… Well, I’m just happy of being back.

My problem is that, when updating to Pulsar v3.0 PC had a few problems with the drivers, corrected them matching the drivers, now when I open Pulsar, everything works well till I close it and try to use the program again. The only way for me to open Pulsar again, is to reinstall everything; this is not very handy is it? This is the Message I get:

“Could not close the current CreamWare background application!”

What can I do, please, what should I do to solve this problem? Thanks for your answers.

You will probably need to rebuild the background project, if you're trying to use an older V2 project as a background project you may get this, download V3.01 update and apply it, this will overwrite your background project with a clean one, and see if that fixes it.

PS - Welcome back - we missed you.

No solution Nestor, but a welcome back. I asked in another thread a few months ago what had happened to you, but no one knew. You gave me lots of good advice when I first began with Pulsar, and you always remember who helped you as a newbie

I’m surprised you both still remember me. Well… I’m very sensitive to those kind of things, thanks very much indeed. Many things happened to me; I’ve changed continent, life, girlfriend, work, language, etc., etc., etc., even the poor cat was put away cos they asked me so many stupid conditions to travel with it, that I gave up. BUT… I still with my Pulsar, there is no other way… je je je…

Thanks very much for your welcome. D: I’ll just install 3.01 to see what happens…