Page 1 of 1
Posted: Sun Jan 06, 2002 5:21 am
by KENZO
My pc's os is windows xp.
When I use PULSAR MIXER,
PULSAR DEVICE'out put into stereo channel.
One of the two's channel stops making sound.
But PULSAR DEVICE'out put into analog dest
direct,
both channel makes sound.
This condition comes out anothe MIXER,
and compressor started.
Somebody,please help me.
Regards
from JAPAN
Posted: Sun Jan 06, 2002 1:47 pm
by at0m
Did you first load a mono compressor and the set the channel to stereo? Then there's still a mono compressor in your stero track.
Posted: Mon Jan 07, 2002 5:00 am
by KENZO
Thank you for your reply
This trouble arises, while not using compressor.
Condition of sound stopping coming out on
micromixer,bigmixer and dynamicmixer.
I changed OS to win 98,
But the same condition has still come out.
Is possibly it failure of PULSAR board?
Regards
KENZO from JAPAN
Posted: Mon Jan 07, 2002 5:16 am
by spacef
Hi,
Here is another possible explanation where it comes from :
May be you are doing the following :
- you 1st have MONO channels, you connect stuff to channel 1,2,3 etc
- Then you press stereo : what is created is NOT a group made of channel 1 + 2, but a new channel 1 Right channel, which has no connection.
So may be that's it ? check in the project if the new stereo channel (1 R and 1 L) are correctly connected ( 1 R should not be connected to anything)
Otherwise, i don't know.
Posted: Mon Jan 07, 2002 6:10 pm
by KENZO
Thank you for your reply
I try re-install PULSAR board.
Then that condition stopped coming out.
It seems that the trouble was solved although I do not understand well.
thanks