Does ASIO work with the new scope 7?
I'd like to route the analog ins from my A16 and the Ferrofish a16 into the adat ins on the 2 pulsar cards?
I added the 2 ADAT sources, then added asio 32 destination and added a bunch of channels then routed the pulsar 2 ADAT source to the asio destination.
Then went to ableton 10.1.25 and tried to enable the asio scope but it says it failed to open the asio scope
Any help is greatly appreciated
D
Asio in Scope 7 w/ win11 & ableton 10.1.25
Re: Asio in Scope 7 w/ win11 & ableton 10.1.25
Ableton in win8 compatibilty mode.
Re: Asio in Scope 7 w/ win11 & ableton 10.1.25
Went to actual app in the pep folder and right clicked and changed to win8 compatibility.
Tried that with no luck.
Tried that with no luck.
Re: Asio in Scope 7 w/ win11 & ableton 10.1.25
Does scope 7 have to be in any compatibility or run as admin ?
Re: Asio in Scope 7 w/ win11 & ableton 10.1.25
Scope 7 will be set for Admin by default, but should not be set to any compatibility mode.
Ableton's shortcut should be set to compatibility for Win 8.1
Ableton's shortcut should be set to compatibility for Win 8.1
Re: Asio in Scope 7 w/ win11 & ableton 10.1.25
Does Scope prompt for elevated privs when launching?
Try the ASIO2-32 Source 64 & ASIO2 Dest-64 pairs, set them to 2-4 channels each.
Did you enable the selected i/o's from Ableton's panel?
Try the ASIO2-32 Source 64 & ASIO2 Dest-64 pairs, set them to 2-4 channels each.
Did you enable the selected i/o's from Ableton's panel?
Re: Asio in Scope 7 w/ win11 & ableton 10.1.25
It works now thanks to Gary's suggestion to use the asio 2