old devices and screen sets

An area for people to discuss Scope related problems, issues, etc.

Moderators: valis, garyb

Post Reply
nebelfuerst
Posts: 479
Joined: Tue Jun 23, 2009 10:55 am

old devices and screen sets

Post by nebelfuerst »

I'm using screen sets to revert to a defined setup.

In legacy projects, I use bigmixerV2 and some dna-equalizers.
Klicking on "Set 1" shows dna-devices, but no bigmixer.
So I have to click on "Set2" and back to "Set1" to make bigmixerV2 and dna-devices appear.

Is there a way to improve ? ( Beside not using legacy devices like bigmixerV2 :D )
\\\ *** l 0 v e | X I T E *** ///
djmicron
Posts: 1181
Joined: Wed Jul 23, 2003 4:00 pm
Location: Milano

Re: old devices and screen sets

Post by djmicron »

Tested with Big Mixer V2 and V1 and both are compatible with screen sets.
To save the the state of the screen you have to unlock and then lock again the corresponding screenset padlock.
Other than that, Big Mixer has some phase issues if I remember right.
nebelfuerst
Posts: 479
Joined: Tue Jun 23, 2009 10:55 am

Re: old devices and screen sets

Post by nebelfuerst »

I looked into the problem once again.
Part of my problem is, that bigmixer drops behind the routing window, when I click the routing window.
( micromixer stays in front.)
Why is there a difference ?
\\\ *** l 0 v e | X I T E *** ///
djmicron
Posts: 1181
Joined: Wed Jul 23, 2003 4:00 pm
Location: Milano

Re: old devices and screen sets

Post by djmicron »

it's because the Big Mixer doesn't have the "keep on top" option. To avoid that problem you can simply save a screenset with the routing window closed and with the Big Mixer surface opened.
Post Reply