Edius/Wav-driver
Posted: Wed Dec 04, 2019 12:23 am
I have 2 Pulsar II cards installed which are connected with a Yamaha 01V and a Behringer Ultragain Pro 8 by ADAT with a total of 24 channels (see attachment). This works fine as long as I am in Cubase, Wavelab or other programs that use the Asio driver.
Unfortunately I can't get the system to work with EDIUS. EDIUS seems to use the sound device that is activated in Windows. In my case thats "LINE (4- Sinic Core Pulsar2)". It works well for the output but fails for the Input. I can not get a correct signal into Edius. The only signal I got was a distorted hum or undefined noise, looking like some artefacts from the digital connection or time code or so.
I tried different devices in the scope project file without success. Besides others tried to use the standard wave drivers instead of the 24-bit drivers. Whenever I did that the PC crashed and I got a bluecreen. Is that normal?
Is there a solution for this problem and, if so, can someone guide me through this?
Unfortunately I can't get the system to work with EDIUS. EDIUS seems to use the sound device that is activated in Windows. In my case thats "LINE (4- Sinic Core Pulsar2)". It works well for the output but fails for the Input. I can not get a correct signal into Edius. The only signal I got was a distorted hum or undefined noise, looking like some artefacts from the digital connection or time code or so.
I tried different devices in the scope project file without success. Besides others tried to use the standard wave drivers instead of the 24-bit drivers. Whenever I did that the PC crashed and I got a bluecreen. Is that normal?
Is there a solution for this problem and, if so, can someone guide me through this?
