PlanetZ forums - scopeusers.com

Hi, So I wanted to try ScopeSync / BCModular lately and started to watch the tutorial videos.

Then when I had to add modules inside modular IV (scope sync 128 pannel I think), I disovered that I can not add any modules inside the modular window...

I tried to load an empty modular patch, try to add a few modules : nothing happens. The modules are listed correctly at the top of the modular window, but nothing happens when I click to add a module.

I check the modules path in the settings, also in cset.ini, it is ok.

Also, when I load any existing modular patch, it loads and works correctly, all the modules are loaded.

It's just that I can't add any module now...

So I tried a clean install of the latest scope release : V7.1706, and it's the same ! when I open an empty modular (I,II,III, or IV) and try to add any of the listed modules, nothing happens !

Please help me...

only click is not enough
>>test this
v1) click on list entry then drag&drop into shell
or
v2) open system-ordner-path > mod-file > drag&drop into shell

Oh... I see, I will try that this afternoon thanks !

EDIT: so that was it... I find it weird that the module is not just added somewhere if you simple click on it, but that's ok.

Coming from a Nord, I had the same initial experience, but it all works in the end.

that's professional and intelligent,
you put your module in the right place of your shell!
...you are the master and say what>where>who
scope is your domina slave
and she love´s you yeah yeah yeah...