PlanetZ forums - scopeusers.com

Not a problem, more of a query.
How do you assign effects on the 8 sub-outs of the Pulsar Mixer!!
I seem to be limited to applying the fx only to the Master Mix Outputs only.
Any suggestions.

Is this possible or am i just wasting my time trying to figure this out here, someone must know.

Osc

I'm not sure I quite understand the question, but I'll give it a shot. You can assign effects to every channel in the mixer, via AUX Sends and Inserts.

In the BUS section, you have the AUX Sends and AUX returns, and can assign various channels to groups.

You can effect any channel of the mixer inside the mixer, or by wiring up the effect outside the mixer. You might find Aux Sends and Channel inserts to be what you're looking for.

I understand that you're trying to effect the BUS outputs, but not why you're trying to add the effects at that point in the signal chain, maybe you could explain more...

I have 8 Adat Channels going into Pulsar Mixer Channels 1-8. I want to add effects to these channels/signal from the AUX Sends A1-A6 Part of the mixer and route them back out the Pulsar mixer 8 Busouts via Adat.

Osc