PlanetZ forums - scopeusers.com

I am doing surround mixing for a project using Logic 4.8.1 and Pulsar 3.01.

I'm using two A16.s. One for the 6 individual outs for the seperate speaker outputs.

However when I wire the mix out of the Pulsar Mixer to the 6 outputs I don't get full panorama mixing.
Instead I get Panning in pairs.
In other words I can't take a single track and make it's output sound from each individual speaker.

I would like to have the vocal travel to each speaker individually as in a circle affect.

Should I bypass the Pulsar Mixer and go Asio direct?

Do I need Zplane for this? Or can it be done with the setup I described?

Thanks
Niki

Art.No. MOP-16E1
SM 166
5.1 Surround Mixer
89.00 EUR
Available at the Creamware OnlineShop....

Or you can use Logic via ASIO drivers directly to your outputs.

Kim.

<font size=-1>[ This Message was edited by: kimgr on 2001-12-01 14:18 ]</font>