Posted: Sat Jan 13, 2001 11:41 pm
PROBLEM: opening the Pulsar icon on the control bar, or the Pulsar program after Windows 40.10.2222A started up, no Sample Rate appears, even if I switch between master and slave. No audio software can run or find asio drivers (infact no project is loaded). I suppose no cards are founded. I had this problem with Pulsar II card until I up-graded the software to 2.04 version; I worked fine for few days, but when I added a Pulsar II SRB the problem reappeared.
ALREADY TRIED: completely disinstalled the software; interchanged Pulsar II and II SRB cards on the slot 2 and 3 (already tried slot 1 and 4 without success because of conflict with agp and pci); actually IRQ 5 and 9 without conflicts and only a scsi board on slot 1 with IRQ 11; USB disabled; connected the two Pulsar cards together with one and/or two cable (usually the one nearest the front panel).
I temporary solve the problem removing one card or disconnecting the Pulsar and SRB cable.
I cannot work this way!!!! I NEED YOUR HELP
ALREADY TRIED: completely disinstalled the software; interchanged Pulsar II and II SRB cards on the slot 2 and 3 (already tried slot 1 and 4 without success because of conflict with agp and pci); actually IRQ 5 and 9 without conflicts and only a scsi board on slot 1 with IRQ 11; USB disabled; connected the two Pulsar cards together with one and/or two cable (usually the one nearest the front panel).
I temporary solve the problem removing one card or disconnecting the Pulsar and SRB cable.
I cannot work this way!!!! I NEED YOUR HELP