Page 1 of 1
phase in scope analog dest (xlr)
Posted: Sat Jul 04, 2015 8:59 am
by ARCADIOS
Hi after a long time
Is there a chance that scope dest xlr outs to be sending phase L or R INVERTED??
Re: phase in scope analog dest (xlr)
Posted: Sat Jul 04, 2015 9:31 am
by garyb
anything is possible depending on what is in chain, but normally, no. this is impossible.
Re: phase in scope analog dest (xlr)
Posted: Sat Jul 04, 2015 9:59 am
by ARCADIOS
nothing wrong in chain
connected also my pulsar rca dest... and seems to be ok...(not inverted) ...
also my cables are ok I suppose since I took a look at the collors of the TRS soldering (IF THAT PLAYS A ROLE).....
Now for having the correct phase in scope analog dest.. I connected ..in between.. a scope channel with L phase Inerted..
BTW nice talking to you again.... always there scope family......
Now to say a joke.....
Greece is in the middle (eye) of the cyclon... and I fix my PHASE issues..... hahahahaha
Re: phase in scope analog dest (xlr)
Posted: Sat Jul 04, 2015 10:52 am
by garyb
hmm...
well, if it works...
i suspect that somewhere in the hardware chain, there's something that has inverted phase. checking the trs adaptors was a good place to check, anyway.
good to hear from you, too!
Re: phase in scope analog dest (xlr)
Posted: Sun Jul 05, 2015 1:11 am
by ARCADIOS
you were right
I checked the xlrs coming from scope' outs..... the Left channel was the problem...
these were cables I made the soldering.. about 2 years ago...
I had soldered by mistake the hot(red) cable to pin3 instead of pin2 and viceversa...
everyhting fine now....
Re: phase in scope analog dest (xlr)
Posted: Sun Jul 05, 2015 8:30 am
by garyb