PlanetZ forums - scopeusers.com

Hi folks,
I' m new here, would post these questions, all suggestions will be appreciate:
1) can I run 2 Pulsar II Classic boards togheter (I have all old keys but one is 3.1c software - other 4.5) connecting them thru STDM cable, under XP without new activation keys?
2) updating to new win7 drivers, can I have 2 partitions (XP + win7) on same system disk to access past projects?
Thanks very much

1. sure. you can use v4.5. only one card needs keys.

2. you could, but i think that would be more trouble than it's worth.
with a very few exceptions, projects from mearlier versions of Scope should open just fine in v5.1. you can't have an older installation active on the same partition as v5.1, is the main restriction.

Many thanks mate! I' ll proceed with 4.5 for now....

garyb wrote:1. sure. you can use v4.5. only one card needs keys.

2. you could, but i think that would be more trouble than it's worth.
with a very few exceptions, projects from mearlier versions of Scope should open just fine in v5.1. you can't have an older installation active on the same partition as v5.1, is the main restriction.