Page 1 of 1
Scope 5.1 with 3 PCI cards id changes automatically.
Posted: Sun Dec 21, 2014 9:56 am
by Saverio
My system Scope comprises three PCI cards in a computer in 1155, after a few weeks spent modify settings, and change the position of the tabs in the slots, I found the right confifurazione, Board0 Pulsar2 6Dsp, Board1 Luna2 3Dsp, Board3 Scope 15dsp, but the system does not keep the settings, change the settings on each reboot and Scope 15dsp becomes Board0 and sisteme becomes perform poorly, there is a solution to block the ID? thank you
Re: Scope 5.1 with 3 PCI cards id changes automatically.
Posted: Sun Dec 21, 2014 10:52 am
by fidox
did you try to change/add settings in cset.ini file.
like (for example)
[board0]
boardid=1
[board1]
boardid=0
[board2]
boardid=2
?
Re: Scope 5.1 with 3 PCI cards id changes automatically.
Posted: Mon Dec 22, 2014 1:29 am
by Saverio
Thanks, I read the manual, and I solved the problem, at least I hope, even if the performance of the Scope vary, however, and many times I must riscivere the project, to start it again, thanks to the next.
